Maxtor 16Channel Stand Alone DVR Manuel d'utilisateur télécharger pdf (Page 282)

270

balance is not accurate. Please note the video may not be

attractive if the value is too low. The recommended value

ranges from 40 to 60.

Gain

The gain adjust is to set the gain value. The smaller the value

is, the low the noise is. But the brightness is also too low in the

dark environments. It can enhance the video brightness if the

value is high. But the video noise may become too clear.

White level

It is to enhance video effect.

Color mode

It includes several modes such as standard, color. You can

select corresponding color mode here, you can see hue,

brightness, and contrast and etc will adjust accordingly.

7.8.1.2 Video and Audio

7.8.1.2.1 Encode

The encode interface is shown as below. See Figure 7-19.

Figure 7-19

Please refer to the following sheet for detailed information.

Parameter

Function

Channel

Please select a channel from the dropdown list.

Video enable

Check the box here to enable extra stream video. This item is

enabled by default.

Code stream

type

It includes main stream, motion stream and alarm stream. You

can select different encode frame rates form different recorded

events.

System supports active control frame function (ACF). It allows

you to record in different frame rates.

For example, you can use high frame rate to record important

events, record scheduled event in lower frame rate and it allows

you to set different frame rates for motion detection record and

alarm record.

alarm shop

1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 357 358

Pas de commentaire

Maxtor 16Channel Stand Alone DVR Manuel d'utilisateur Page 282