Maxtor SSA-0412 Manuel d'utilisateur télécharger pdf (Page 18)

2. Rear Panel and Connections

Figure 2.1. Rear Panel

Table 2.1. Rear panel connections

Connection DESCRIPTION

n VIDEO IN

Four connectors for video input. Connect camera output to Video-in (NTSC/PAL)

o AUDIO IN

Four connectors for audio input.

p AUDIO OUT

One connector for audio output.

q VIDEO OUT

Composite video output in NTSC or PAL format

r RS-232

For engineering use only

s VGA

Connector for VGA monitor

t ETHERNET

RJ45 connector for LAN connection

u RS-485/422

For camera control use

v SENSOR IN

Connector for sensor device connection. 4 sensors can be connected to the equipment

sensor 1, 2, 3, 4 are dedicated to Video channel 1, 2, 3, 4, respectively. Either normal

open (NO) or normal close (NC) sensor can be selected for each sensor. Simple On/Off

switching.

w ALARM OUT

Connector for alarm device connection.

Provides simple On/Off switching using relay. 0.5A/125V, 1A/30V

DC INPUT

Apply 12V DC using the DC adaptor supplied with the equipment.

SWITCHES

PAL

Set to ON position when video is PAL

VGA

Set to ON position when VGA monitor is used.

* Refer to the detail setting of video switch on Page 7 “Video Signal Select / Setting”.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 72 73

Pas de commentaire

Maxtor SSA-0412 Manuel d'utilisateur Page 18