Maxtor SATA/150 Guide d'installation télécharger pdf (Page 10)

6Installing the Hard Drive

Setting the Jumper

Most Maxtor hard drives come preconfigured with a jumper (Figure 4) in

the cable select or master position. Maxtor recommends using the cable

select jumper position in most situations for ease of configuration.

After removing the drive from its anti-static bag, match the jumper

block on the rear of the drive to one of the jumper block styles

shown in Figure 6. If you are unable to match your drive jumper

block to one of the styles shown, refer to the jumper settings dia-

gram on the drive label.

Conﬁgure the drive as cable select (CS) by using pliers to move the

jumper into the appropriate position on the jumper block.

To properly configure cable select, all devices on the same ATA cable

must use the cable select jumper setting and be connected with a 40-

pin Ultra ATA cable like the one included. Before installing a new hard

drive on an ATA cable with an existing device, confirm that the existing

device is configured as cable select. Jumper settings may be printed

on the device; however, you may need to consult the device

documentation or contact the manufacturer.

Older systems that do not support Ultra ATA/66 or are dated prior

to November 1998 may not be able to use the cable select jumper

option. If you are uncertain whether your system can use the cable

select option, consult your system manual, contact the system

manufacturer, or use the master/slave jumper settings instead.

Figure 4

A Jumper

Determine the jumper style and settings

using Figure 6 on page 7 or the diagram on

the drive label.

Style A1 Style A2

Style B

Figure 5

Common Jumper Blocks

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Pas de commentaire

Maxtor SATA/150 Guide d'installation Page 10