Maxtor SATA/150 Guide d'installation télécharger pdf (Page 18)

14 Installing the Hard Drive

corner of your keyboard. (Figure 12) Press Enter to resume

system boot.

Some monitors are slow to display text during boot, so you may

need to restart the computer to read the message.

Immediately after the function key message appears, press

the indicated key to enter Setup.

Within the BIOS Setup utility,

navigation is limited to keyboard commands. The active function

keys are usually Esc, Tab, Page Up, Page Down, Enter, +, -,

spacebar, number, and arrow keys. The BIOS Setup utility usually

has keyboard instructions located somewhere on the screen.

Upon entering Setup, highlight the Auto-Detect IDE HDD/Hard

Drives option (if displayed) and press Enter.

This will allow the

system to automatically detect the devices on your primary and

secondary ATA channels. If there is no Auto-Detect option

available, choose Standard CMOS.

If you are unable to locate the function key message to enter

CMOS Setup or are experiencing difficulty with hard drive

detection in the BIOS, refer to your system manual or contact

the system manufacturer.

After the hard drives are detected, save the settings.

Exit Setup and power off the system.

Figure 12

Pause/Break Key on a Keyboard

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Pas de commentaire

Maxtor SATA/150 Guide d'installation Page 18